If you’ve replaced the regular indicator or tail light bulbs on your bike with brighter LED ones, you may find the new bulbs are either flashing too quickly or are blowing.
Regular bulbs have less resistance than LED bulbs so the simple way to solve these problems is by fitting a resistor parallel to each side (2 bulbs).
The resistor needs to be wired to the ground and turn/tail wires of each side and once installed will:
Correct too-fast flashing
Stop bulbs blowing
Specifications:
6 ohm
25 watt
Pre-wired
Wire length (each): 31cm (12”)
Resistor dimensions: 2.8 x 2.8 x 1.4cm (1.1 x 1.1 x 0.5”)
This set is brand new and unused and includes the following:
Tips: Please to make clear all relevant questions with us before buying, our staff will give you response within 12 hours. Due to there are too many uncertain factors in different batch, certain responses are ensured in 3 days.